[fpc-devel] Is target mips-embedded possible / planned?

Michael Ring mail at michael-ring.org
Thu May 16 09:55:27 CEST 2013

Nice find, question is why did I not find this link ;-)

I etched some testboards yesterday and connected them to my 
ARM-USB-TINY, openocd detects the chip just fine but Michel was right, 
flash read performance is a mess, it took two minutes to read out the 
32k flash of my pic32mx220 chip, that's pretty slow. I will check if a 
j-link or st-link work better, but I do not have high hopes.

But perhaps the ejtagproxy or pic32prog can solve this problem, will 
keep you posted.


Am 16.05.13 08:53, schrieb Michael Schnell:
> On 05/15/2013 12:11 PM, Michael Ring wrote:
>> If you find the time to find out how to actually start up & use their 
>> gdbserver I will be more than happy to integrate it into lazarus, 
>> right now I take what I can get and that seems to be openocd.
> Maybe this helps....
> http://olimex.wordpress.com/2012/07/23/ejtagproxy-opwn-source-gdb-interface-for-pic32-and-mips/
> "EJTAGproxy open source GDB interface for PIC32 and MIPS"
> They say "PIC-KIT3 <https://www.olimex.com/dev/pic-kit3.html> (ICSP) 
> andARM-USB-TINY <https://www.olimex.com/dev/arm-usb-tiny.html>(JTAG) 
> interfaces are supported."
> -Michael
> _______________________________________________
> fpc-devel maillist  -  fpc-devel at lists.freepascal.org
> http://lists.freepascal.org/mailman/listinfo/fpc-devel

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.freepascal.org/pipermail/fpc-devel/attachments/20130516/39648da6/attachment.html>

More information about the fpc-devel mailing list