[fpc-devel] Is target mips-embedded possible / planned?
mschnell at lumino.de
Thu May 23 11:06:52 CEST 2013
On 05/23/2013 10:50 AM, Martin Schreiber wrote:
> Or the gdbserver runs on the PC and communicates with a debug interface
> hardware. MSEide uses this approach to debug AVR32 code with the "AVR ONE!"
> debugger and ARM chips (for example Energy Micro Tiny Gecko) with the Segger
> J-Link debugger which is built-in in the inexpensive demo board.
I did not expect that someone would be inclined to go this way, as you
need to implement the (published but rather "internal") gdb<->gdbserver
pipe protocol, and additionally you need to do the arch-dependent
interpretation in your own software rather than have gdb do this and
provide the results via it's well-understood command line pipe interface.
But obviously you did have good reasons to do so. (Can you provide a
short explanation, why ?)
What kind of interface does "AVR ONE!" provide ? Does it come with a
gdbserver type of "driver" on the PC ?
BTW.: can you say anything regarding the PIC32 debugging issue ?
More information about the fpc-devel