[fpc-devel] x86_64 Optimizer Overhaul

Ryan Joseph ryan at thealchemistguild.com
Sun Dec 9 04:13:45 CET 2018



> On Dec 9, 2018, at 9:02 AM, J. Gareth Moreton <gareth at moreton-family.com> wrote:
> 
> (This should probably be on the mailing list because it's helpful to everyone)
> 
> Hmmm, I'm not sure about that one - those shouldn't be affected.  Just the standard "make clean all" should work.
> 
> However, the document here contains everything about building FPC: http://www.stack.nl/~marcov/buildfaq.pdf - not sure why your packages aren't in the default directories now though... the patches only change a few source files.
> 
> Gareth aka. Kit

The reason is that PPU versions changed so I can’t use the units at the default system locations. Not sure how the compiler decides but it was looking for units at the 3.1.1 install location which is an older PPU version.

There should be a single command to specify a top-level directory that wins out over default locations.

Regards,
	Ryan Joseph




More information about the fpc-devel mailing list