[fpc-devel] make error in fcl-web

[Joost van der Sluis]

On Sun, 2011-04-03 at 21:11 +0100, Martin wrote:
> On 03/04/2011 20:59, Martin wrote:
> > On 03/04/2011 20:50, Martin wrote:
> >> (w32 / vista)
> >> I tried to recompile fpc trunk, it starts up fine, until it comes to 
> >> fcl-web. I copied the last lines of output to the end of the mail
> >>
> >> Not sure about the exact make command that was running, since they 
> >> come from a batch file, but probably the 2nd line:
> >> make.exe clean distclean
> >> make.exe all   LINKSMART=1  CREATESMART=1  OPTIMIZE=1  OPT="-gl -O3 
> >> -Or -CpPENTIUMM -OpPENTIUMM"  TARGET_EXAMPLES=NO 
> >> FPC=c:\FPC\SVN\ppc386_2_4_2.exe
> >> make.exe install  INSTALL_PREFIX=c:\FPC\trunk\  COPYTREE=echo 
> >> UPXPROG=echo
> >>
> >> Found this in svn, and will try with the revision before...
> >>
> >> Revision: 17223
> >> Author: joost
> >> Date: 14:33:56, 02 April 2011
> >> Message:
> >>  * Let the makefile create the unit output dir when fpmake.pp is not 
> >> compiled yet
> >> ----
> >> Modified : /trunk/packages/fcl-web/Makefile
> >> Modified : /trunk/packages/fcl-web/Makefile.fpc
> >>
> > no difference, same error
> just some more info.
> 
> after trying (and getting the error) to compile with rev 17222, I went 
> to the director (to rename the old makefile).
> 
> There is a fpmake.exe, with todays date, and a 3 minute old timestamp.
> I do not know if that was created by this attempt, or by the previous 
> attempt (that was with includign the above revision)

Are you doing a cross-compilation? In that case the fpmake.exe is
probably build for the target you were compiling for.

Joost.